Gas-Gas Shell & tube heat exchanger Geurts Heat Exchangers Engineering, production and supply of a shell & tube heat exchanger made out of stainless steel, for heat transfer of LP steam to nitrogen. Design code PED 2014/68/EU + RTOD.
The very broad range of Barriquand plate heat exchangers and shell and tube heat exchangers covers all steps in the processing and transport of the various sources of hydrocarbons (oil, methane, shale gas, etc.). During refining:Evaporator, condenser; Cooler for gas scrubbing water (quench water coolers) Amine recovery on gas cleaning Shell and tube heat exchanger Engineering Fandom
Shell-and-tube heat exchangers are used widely in the chemical process industries, especially in refineries, because of the numerous advantages they offer over other types of heat exchangers. A lot of information is available regarding their design and construction. The present notes are intended only to serve as a brief introduction. Section 5.4 Shell and Tube Heat Exchanger CorrectedA miniature shell-and-tube heat exchanger is designed to cool engine oil in an engine with the engine coolant (50% ethylene glycol). The engine oil at a flow rate of 0.23 kg/s enters the exchanger at 120°C and leaves at 115°C. The 50% ethylene glycol at a rate of
Your email address will not be published.*